হ্যালোজেন হিটার ল্যাম্প ২৩০ভি ১০০০ওয়াট

Sun, 07 Jun 2026 03:13:24 +0800

On the blow molding floor, a preform temperature profile that’s off—or drifting—will stop the line just as fast as any mechanical failure. When the heating tunnel can’t hold setpoint, you end up with inconsistent stretch, stress lines, and scrap bottles. We built the Halogen Heater Lamp 230V 1000W to put repeatable heat control back where it belongs: in the PET stretch blow molding machine. What matters, technically This is a short-wave infrared halogen emitter, putting out 1000W at 230V. That gives you stable output with fast response in the preform heating zones. The quartz envelope transmits infrared energy efficiently, heating the preform surface first, then letting internal heat catch up by conduction. The R7s base and standard mounting dimensions match the sockets and reflector assemblies you’ll find on common blow molders, so you can swap a lamp without reworking the heating module. Why it works where it matters Blow molders live and die on heat timing. With this lamp, you tighten temperature tolerance across the heating tunnel, which means fewer rejects from uneven wall thickness and weak necks. The fast on/off response supports shorter cycle times and cuts down on idle heat soak, so repeatability holds shift after shift. In practice, that translates to more good bottles per hour and less downtime chasing temperature drift. Here are the practical details Halogen lamps are high-intensity emitters, so reflector alignment and clean quartz surfaces directly impact heating uniformity. Make sure the lamp is seated correctly and the terminal connections are tight—machine vibration will loosen contacts over time. And keep airflow in the heating zone consistent. If airflow changes, convective cooling shifts, and the preform temperature curve can drift even when lamp output is spot on.

১০০০W on The Quartz Heater Marketplace

হ্যালোজেন হিটার ল্যাম্প ২৩০ভি ১০০০ওয়াট